LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Sender Access Hole Cover
    GM1671970Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear compartment liner. Refer to Rear Compartment Liner Replacement .
  2. Remove the fuel sender access hole cover bolts.
  3. Remove the fuel sender access hole cover.
    4. Fig 2: Identifying Fuel Level Sensor Wiring Harness Electrical Connector
    GM1671971Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel level sensor wiring harness electrical connector (1) fuel tank pressure sensor.
  5. Remove the fuel tank pressure sensor.
scientia non olet · About LEMON Manuals