LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Level Sensor Wiring Harness Electrical Connector
    GM1671971Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor.
  2. Connect the fuel level sensor wiring harness electrical connector (1) to the fuel tank pressure sensor.
    3. Fig 2: Identifying Fuel Sender Access Hole Cover
    GM1671970Courtesy of GENERAL MOTORS CORP.
  3. place the fuel sender access hole cover into position.
    4. NOTE: Refer to Fastener Notice .
  4. Install the fuel sender access hole cover bolts.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Install the rear compartment liner. Refer to Rear Compartment Liner Replacement .
scientia non olet · About LEMON Manuals