Removal Procedure
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the right secondary camshaft drive chain tensioner. Refer to Secondary Camshaft Drive Chain Tensioner Replacement - Right Side .
- Remove the camshaft position (CMP) sensor. Refer to Camshaft Position Sensor Replacement .
- Remove the right camshaft cover. Refer to Camshaft Cover Replacement - Right Side .
- Ensure both camshaft sprocket drive pins are at the top of their rotation.
- Install the J 44212 over the camshafts. See Special Tools .
- Remove the mechanics wire (1) supporting the right secondary camshaft drive chain shoe (3).
- Remove the engine front cover bolt (2) from the front of the engine.
- Use an open end wrench on the hex cast into the camshaft in order to prevent the camshaft from rotating when removing the camshaft sprocket bolt.
- Remove the right exhaust camshaft sprocket bolt.
- Slide the right exhaust camshaft sprocket off of the camshaft and remove the right secondary camshaft drive chain from the camshaft sprocket teeth.
- Lift the right secondary camshaft drive chain from the camshaft intermediate drive shaft sprocket teeth.
- Remove the right secondary camshaft drive chain from the engine.
- Clean and inspect the camshaft timing drive components. Refer to Camshaft Timing Drive Components Cleaning and Inspection .
CAUTION:
Refer to CAMSHAFT HOLDING TOOL CAUTION
.
NOTE:
Refer to Torque Reaction Against Timing Drive Chain Notice
.