Front Bumper Fascia Support Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fascia Support Replacement - Front Bumper

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the distance sensing cruise control module, if equipped. Refer to DISTANCE SENSING CRUISE CONTROL MODULE REPLACEMENT Remove front fascia. Refer to Front Bumper Fascia Replacement .
1	Bolt, Front Fascia Support (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Bolt, Front Fascia Support (Qty: 2) Tighten: 10 N.m (89 lb in)
3	Support, Front Fascia