LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Frame And Underbody) >> Repair Instructions >> Support Replacement - Rear (W/FE1, FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Support Bracket Retaining Bolts
    GM105035Courtesy of GENERAL MOTORS CORP.
  1. Raise the support assembly with the transmission jack in position.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 rear bolts and the 2 front bolts at the mounts.

    Tighten:  Tighten the bolts to 191 N.m (141 lb ft).

    3. Fig 2: View Of Rear Suspension And Mounting Bolts
    GM105036Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Loosen the assemble brackets to prevent spinning when securing the front support assembly bolts.
  3. Install the brackets at the forward support assembly mounts.

    Tighten:  Tighten the bolts to 86 N.m (63 lb ft).

    4. Fig 3: Identifying Road Sensing Suspension or Automatic Level Control Electrical Connectors & Vent Hose
    GM293366Courtesy of GENERAL MOTORS CORP.
  4. Install the air tube to the electronic level control compressor.
  5. Connect the electronic level control electrical connector and install the vent tube.
  6. Connect the electrical connectors to the support assembly (FE3).
  7. Install the electronic level control link (FE1) or links (FE3) to the control arms.
  8. Install the brake calipers. Refer to Rear Brake Caliper Replacement (J55) or Rear Brake Caliper Replacement (JL9) .
  9. Install the springs. Refer to Coil Spring Replacement (FE1 and FE3) or Coil Spring Replacement (FE7) .
  10. Install the exhaust system. Refer to Exhaust System Replacement .
  11. Install the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals