Rear Side Door Window Regulator Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Window Regulator Replacement - Rear Door

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Position the rear door window approximately half way down in the door. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement . Tape the window to the door frame to prevent it from moving.
1	Nut, Rear Door Window Regulator (Qty: 3) Tip: Loosen the window to regulator bolts. Release the window regulator from the window and door. Tighten: 9 N.m (80 lb in)
2	Regulator, Rear Door Window Tip: Disconnect the electrical connector from the regulator.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Position the rear door window approximately half way down in the door.
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
Tape the window to the door frame to prevent it from moving.

Nut, Rear Door Window Regulator (Qty: 3)
Tip:

Loosen the window to regulator bolts.
Release the window regulator from the window and door.

Tighten: 9 N.m (80 lb in)

Regulator, Rear Door Window
Tip: Disconnect the electrical connector from the regulator.