LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (HVAC System - Automatic) >> Repair Instructions >> Heater and Air Conditioning Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: I/P Accessory Trim Plate
    GM1653218Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors to the HVAC control module assembly.
  2. Install the HVAC control module assembly into the I/P.
  3. NOTE: Refer to Fastener Notice .
  4. Install the HVAC control module assembly screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  5. Install the I/P accessory trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement or Instrument Panel Accessory Trim Plate Replacement - Left Side .
  6. Refer to Control Module References for replacement and setup information.