LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Clutch Pedal Assembly
    GM1302122Courtesy of GENERAL MOTORS CORP.
  1. Position the clutch pedal assembly over the studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the clutch pedal assembly nuts.

    Tighten:  Tighten the clutch pedal assembly nuts to 20 N.m (15 lb ft).

    3. Fig 2: Identifying Retainer At Clutch Master Cylinder Push Rod
    GM1396381Courtesy of GENERAL MOTORS CORP.
  3. Insert a new retainer (3) into the clutch master cylinder push rod (1).
  4. Push the clutch master cylinder push rod (1) onto the clutch pedal pin to secure.
    5. Fig 3: Clutch Release Switch Electrical Connector
    GM1302119Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors (2, 4) to the following components:
    • The clutch pedal position switch (1)
    • The cruise control release switch (3)
  6. Adjust the clutch release switch. Refer to Clutch Pedal Cruise Control Release Switch Adjustment .
  7. Adjust the clutch pedal position switch. Refer to Clutch Pedal Position Switch Replacement .
  8. Check for proper clutch pedal movement and operation.
scientia non olet · About LEMON Manuals