Clutch Pedal Spongy Low Pedal Effort

WARNING: This page is about a different variant/trim than selected.

Cause	Action
DEFINITION: The clutch pedal may feel spongy, or it requires very little effort to operate. Review Symptoms - Clutch and perform the necessary inspections.
Air in the hydraulic system	Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
Master cylinder fluid level low	Inspect for leakage in the clutch master cylinder, hose connections, and the clutch actuator. Repair or replace any faulty components.
Incomplete pedal return	Inspect the pedal for full return. Clear any obstacles that may interfere with the pedal operation. Adjust the clutch release switch. Refer to Clutch Pedal Cruise Control Release Switch Adjustment in Cruise Control.
Clutch incorrectly installed	Remove the clutch and install it correctly. Refer to Clutch Assembly Replacement .
Clutch mounting bolts loose or broken	Remove the broken bolts. Replace the broken or loose bolts, and tighten. Refer to Clutch Assembly Replacement .
Release bearing worn or damaged	Replace the release bearing. Refer to Clutch Actuator Cylinder Release Bearing Replacement .
Contaminated hydraulic fluid	Inspect for the following conditions: The clutch hydraulic fluid for contamination of water The reservoir cap for being faulty if water is present The clutch hydraulic fluid for dirt or debris Flush and bleed the clutch hydraulic system if the above conditions are found. Refer to Hydraulic Clutch Bleeding .