LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - AISIN Ar5) >> Repair Instructions >> Control Lever and/or Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the control lever housing if previously disassembled. Refer to Shift Control Housing Assemble .
  2. Remove the masking from the control lever opening and ensure the sealing surface is clean and dry.
    3. Fig 1: Locating Shift Control Housing & Gasket
    GM880655Courtesy of GENERAL MOTORS CORP.
  3. Place the control lever gasket on to the transmission.
  4. Position the control lever housing assembly to the control lever assembly opening, aligning the bushing with the internal shift control lever.
    5. NOTE: Refer to Fastener Notice .
  5. Install the control lever housing assembly bolts.

    Tighten:  Tighten the control lever assembly bolts to 20 N.m (15 lb ft).

    6. Fig 2: View Of Control Lever Boot
    GM1388967Courtesy of GENERAL MOTORS CORP.
  6. Slide the boot into position over the control lever.
    7. IMPORTANT: Ensure the carpet is not between the boot and the floor panel.
  7. Tilt the boot in order to seat to the floor.
  8. Install the control lever boot screws.

    Tighten:  Tighten the control lever boot screws to 2.5 N.m (22 lb in).

  9. Install the console (w/o D06 only). Refer to Console Replacement (Small W/Manual Transmission) .
  10. Install the shift lever assembly. Refer to Shift Lever Assembly Replacement (D06)  or Shift Lever Assembly Replacement (W/O D06) .
scientia non olet · About LEMON Manuals