LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - AISIN Ar5) >> Repair Instructions >> Shift Control Housing Assemble

Shift Control Housing Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Shift Control Lever Assembly
    GM880940Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the shift lever plungers and the lever spring seat surface of the shift control housing with transmission fluid.
  2. Install the shift control lever assembly into the shift control housing.
    3. Fig 2: View Of Shift Control Lever Retainer & Retaining Bolts
    GM880937Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use a petroleum base or silicon lubricate on the shift control lever seals or boots. If a lubricant is required, use a water base liquid soap.
  3. Install the shift control lever shaft boot in the retainer.
  4. Install a control lever housing gasket to the housing.
  5. Install the shift control lever retainer.
    6. NOTE: Refer to Fastener Notice .
  6. Install the shift control lever retainer bolts.

    Tighten:  Tighten the retainer bolts to 20 N.m (14 lb ft).

    7. Fig 3: Identifying Control Lever Boot
    GM880928Courtesy of GENERAL MOTORS CORP.
  7. Install the control lever boot.
    8. Fig 4: Locating Shift Control Lever Shaft Seal
    GM880926Courtesy of GENERAL MOTORS CORP.
  8. Install the shift control lever shaft seal.
scientia non olet · About LEMON Manuals