Floor Shift Control Knob Replacement
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications
. |
|
| 1 | Shift Control Boot Tip: Push in at the base of the boot to release the locking tabs from the console. When installing the boot press the boot retainer into the console to engage the locking tabs. Ensure the boot is not twisted when installed. |
| 2 | Traction Control Switch Electrical Connector Tip: When installing wrap the connector wire around the front of the shift lever then connect to the mating connector on the shift control. |
| 3 | Shift Control Knob Set Screw Tighten: 2 N.m (18 lb in) |
| 4 | Shift Control Knob |