Diagnostic Aids
- Test the fog lamp switch for sticking in the ON position.
- Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections .
DTC B2527
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Fog Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Step 4 |
| 3 |
|
Go to Diagnostic Aids | Go to Step 4 |
| 4 |
|
Go to Step 7 | Go to Step 5 |
| 5 | Test the signal circuit of the front fog lamp switch for a short to ground. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 6 |
| 6 | Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the front fog lamp switch. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 8 | Replace the BCM. Refer to Control Module References
for replacement, setup and programming. Did you complete the replacement? |
Go to Step 10 | - |
| 9 | Replace the front fog lamp switch. Refer to Headlamp Switch Replacement . Did you complete the replacement? |
Go to Step 10 | - |
| 10 |
|
Go to Step 2 | System OK |