LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Cluster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Instrument Panel Cluster (IPC)
    GM692029Courtesy of GENERAL MOTORS CORP.
  1. Position the IPC to the I/P.
  2. Connect the electrical connector to the IPC.
  3. Install the IPC to the I/P.
    4. NOTE: Refer to Fastener Notice .
  4. Install the screws to the instrument panel cluster.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  5. Install the IPC bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet) or Instrument Panel Cluster Trim Plate Bezel Replacement (GMC, Buick) .
  6. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  7. Install the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  8. If installing a new IPC, program the IPC. Refer to Control Module References .
scientia non olet · About LEMON Manuals