LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Front Bumper Fascia Replacement (TrailBlazer) >> Removal Procedure

Removal Procedure

  1. Remove the grille. Refer to Grille Replacement (Envoy) , Grille Replacement (Rainier) or Grille Replacement (TrailBlazer) .
    2. Fig 1: Identifying Center Fascia Push-Pins
    GM740665Courtesy of GENERAL MOTORS CORP.
  2. Remove the 2 bolts that retain the top of the fascia to the headlamp housing panel.
  3. Remove the push-pin that retains the top of the fascia to the headlamp housing panel.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    5. Fig 2: View Of Fascia-To-Fascia Support Rod Push-Pins
    GM740663Courtesy of GENERAL MOTORS CORP.
  5. Remove the push-pins (3) that retain the fascia to the fascia support rods (2).
  6. Remove the fog lamps from the fascia. Refer to Front Fog Lamp Replacement (Envoy, TrailBlazer) , Front Fog Lamp Replacement (Rainier) or Front Fog Lamp Replacement (TrailBlazer SS) .
  7. Remove the air deflector. Refer to Front Bumper Fascia Air Deflector Replacement .
    8. Fig 3: Identifying Center Fascia Push-Pins
    GM740665Courtesy of GENERAL MOTORS CORP.
  8. Remove the 4 push-pins that retain the bottom of the fascia to the headlamp housing panel.
  9. Release the body side attachment tabs and pull the fascia straight forward from the wheelhouse opening in order to remove the fascia from the vehicle.
scientia non olet · About LEMON Manuals