LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Air Inlet Grille Panel Replacement (Envoy, TrailBlazer) >> Removal Procedure

Removal Procedure

  1. Remove the windshield wiper arms. Refer to Wiper Arm Replacement (GMC Envoy)  or Wiper Arm Replacement (SS) .
    2. Fig 1: Locating Air Inlet Grille Panel/Hood Seal
    GM742164Courtesy of GENERAL MOTORS CORP.
  2. Remove the air inlet grille panel retaining nuts.
  3. Remove the air inlet grill panel push-pin retainers.
  4. Disconnect the washer hose.
  5. Remove the air inlet grille panel from the vehicle, by pulling upwards in order to disengage the retaining clips.
  6. Place the air inlet grille panel on a clean, prepared surface.
  7. Remove the rear hood seal from the air inlet grille panel studs.
scientia non olet · About LEMON Manuals