LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Instrument Panel Trim And Console Trim >> Repair Instructions >> Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet) >> Removal Procedure

Removal Procedure

  1. Tilt the steering wheel to the full down position.
  2. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
    4. Fig 1: View Of Instrument Panel (I/P) Cluster Bezel (Chevrolet)
    GM712814Courtesy of GENERAL MOTORS CORP.
  4. Remove the screws retaining the bezel to the instrument panel.
  5. Remove the bezel from the instrument panel.
  6. If equipped, remove the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement (Chevrolet) or Transfer Case Shift Control Switch Replacement (GMC, Buick) .
  7. Remove the rear wiper washer switch. Refer to Wiper/Washer Switch Replacement - Rear .
  8. If equipped, remove the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement .
  9. Remove the bezel from the vehicle.
scientia non olet · About LEMON Manuals