Fog Lamps Always On

Step	Action	Yes	No
Schematic Reference: Fog Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Verify that the front fog lamps are always ON. Do the front fog lamps operate normally?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Remove the front fog lamp relay. Do the front fog lamps turn OFF?	Go to Step 4	Go to Step 6
4	Ensure that the front fog lamp switch is in the OFF position. Test for a ground signal at the front fog lamp relay control circuit terminal in the underhood fuse block. Refer to Circuit Testing . Was a ground signal found?	Go to Step 5	Go to Step 8
5	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 7
6	Repair the short to voltage in the front fog lamp supply voltage circuit. Refer to Wiring Repairs . Did you complete the repair?	Go to Step 9	-
7	Replace the BCM. Refer to Control Module References for replacement, setup and programming. Did you complete the replacement?	Go to Step 9	-
8	Replace the front fog lamp relay. Refer to Relay Replacement (Attached to Wire Harness) or Relay Replacement (Within an Electrical Center) . Did you complete the repair?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3