Brake Fluid Leak Test
- With engine running at idle and the transmission in "Neutral", depress the brake pedal and hold a constant foot pressure on the pedal. If pedal gradually falls away with the constant pressure, the hydraulic system may be leaking.
- Check the master cylinder fluid level. While a slight drop in the reservoir level will result from normal lining wear, an abnormally low level in reservoir indicates a leak in the system. The hydraulic system may be leaking internally as well as externally. See INSPECTION under MASTER CYLINDER in REMOVAL & INSTALLATION.
- Also, the system may appear to pass this test but still have slight leakage. If fluid level is normal, check the vacuum booster push rod length. If an incorrect length push rod is found, adjust or replace the push rod. See VACUUM BOOSTER PUSH ROD under ADJUSTMENTS. Check the brake pedal travel. See BRAKE PEDAL HEIGHT, FREE PLAY & STOPLIGHT SWITCH under ADJUSTMENTS. Check the parking brake adjustment. See REAR DISC PARKING BRAKE or REAR DRUM PARKING BRAKE under ADJUSTMENTS.
- When checking the fluid level, the master cylinder fluid level may be lower than the "MAX" mark if the front and rear linings are worn. This is normal.