Removal and Installation

REMOVAL 

1. Disconnect the negative battery terminal. Refer to Battery Disconnect .
2. Using a suitable tool release clips and pawls and remove center console side finisher (LH/RH).

   Courtesy of NISSAN NORTH AMERICA, INC.

   	: Metal clip
   	: Front

3. Shift the electric shift selector to the park position.
4. Using a suitable tool release clips and remove shift selector finisher.
5. Disconnect the harness connector from push button ignition switch.
6. Disconnect the harness connector from electric parking brake switch.
7. Disconnect the harness connector from drive mode switch.
8. Remove the electric shift selector bolts and remove the electric shift selector from center console assembly.
9. Disconnect the harness connector from the electric shift selector.

INSTALLATION 

Installation is in the reverse order of removal.

• Check the CVT position. Refer to Inspection