DTC Diagnosis Procedure

1. Check the steering clutch. Refer to Component Inspection .

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Steering clutch is malfunctioning. Replace steering clutch assembly. Refer to Removal and Installation .

1. 1. Disconnect steering force control module and steering clutch connector.
   2. Check the continuity between steering force control module harness connector and steering clutch harness connector.

      Steering force control module		Steering clutch		Continuity
      Connector	Terminal	Connector	Terminal
      E141	26	E140	1	Yes
      	28		3

   3. Check the continuity between steering force control module harness connector and ground.

      Steering force control module		-	Continuity
      Connector	Terminal
      E141	26	Ground	No
      	28

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace malfunctioning component.

1. 1. Check enlarged contact spring of terminal. Refer to How to Check Terminal .
   2. Perform intermittent incident while turning steering wheel. Refer to Intermittent Incident .

Is the inspection result normal?

YES>>

Replace steering force control module. Refer to Removal and Installation .

NO>>

Repair or replace malfunctioning component.