DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen item(Trouble diagnosis content)	DTC detected condition
C1129-54	COMBINE SENSOR(Combine sensor)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Calibration of yaw rate/side/decel G sensor record data signal.
		Threshold	When calibration of yaw rate/side/decel G sensor is not complete.
		Diagnosis delay time	1 second or less

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear the DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

PAST DTC	CRNT DTC
-	Incomplete calibration of decel G sensor ABS actuator and electric unit (control unit)

FAIL-SAFE

The following systems are canceled:

VDC function
TCS function
Brake assist function
Hill start assist function
Brake force distribution function

DTC CONFIRMATION PROCEDURE

PRECONDITIONING
1. If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.
>>

GO TO 2.
CHECK DTC DETECTION
1. CONSULT
  1. Ignition switch OFF.
    NOTE: Wait at least 10 seconds after placing ignition switch to OFF.
  2. Start the engine.
    NOTE: Wait at least 10 seconds after starting the engine.
  3. Select "Self Diagnostic Result" mode of "ABS".
Is DTC "C1129-54" detected?

YES-1>>

"C1129-54" is displayed as "CRNT": Proceed to Diagnosis Procedure .

YES-2>>

"C1129-54" is displayed as "PAST": Inspection End (Erase "Self Diagnostic Result" mode of "ABS").

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO-2>>

Confirmation after repair: Inspection End.