Additional Service When Replacing AFS Control Unit: Description
Perform the following operations when replacing AFS control unit (for details, refer to Work Procedure ):
BEFORE REPLACEMENT
When replacing AFS control unit, save or print current vehicle specification with CONSULT "Configuration" before replacement.
NOTE:
If "READ CONFIGURATION" cannot be used, use the "WRITE CONFIGURATION - Manual selection" after replacing AFS control unit.
AFTER REPLACEMENT
CAUTION:
- When replacing AFS control unit, always perform "WRITE CONFIGURATION" with CONSULT. Or not doing so, AFS control unit control function does not operate normally.
- Complete the procedure of "WRITE CONFIGURATION" in order.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
- If you set incorrect "WRITE CONFIGURATION", incidents might occur.
- Perform "SENSOR INITIALIZE" with CONSULT when replacing the AFS control unit.