Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

>>

GO TO 2.

>>

Repair the terminal and connector.

1. Disconnect the connector of IPDM E/R.
2. Check the resistance between the IPDM E/R harness connector terminals.

   IPDM E/R harness connector			Resistance (Ω)
   Connector No.	Terminal No.
   E120	24	22	Approx. 54 - 66

Is the measurement value within the specification?

>>

GO TO 3.

>>

Repair the IPDM E/R branch line.

Check the power supply and the ground circuit of the IPDM E/R. Refer to Diagnosis Procedure .

Is the inspection result normal?

>>

Replace the IPDM E/R. Refer to Removal and Installation .

>>

Error was detected in the IPDM E/R branch line.

>>

Repair the power supply and the ground circuit.