Diagnosis Procedure
- CHECK DTC WITH HEADLAMP CONTROL UNIT LH
Check that DTC is not detected with headlamp control unit LH.
Is the inspection result normal?
YES
GO TO 2.
NO
Refer to DTC Index .
- CHECK CAN COMMUNICATION SYSTEM DIAGNOSIS
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart .
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace harness.
- REPLACE HEADLAMP CONTROL UNIT LH AND ERASE DTC
- Turn ignition switch OFF.
- Replace front combination lamp LH. Refer to Removal and Installation .
- Turn ignition switch ON.
- Select "Self Diagnostic Result" mode of "H/L control module RH" using CONSULT.
- Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .
Is DTC detected?
YES
Replace front combination lamp RH. Refer to Removal and Installation .
NO
INSPECTION END