Trouble Diagnosis Flow Chart
- CAN SYSTEM TYPE CONFIRMATION
Confirm the CAN system type based on vehicle specification and equipment. Refer to CAN System Specification Chart .
GO TO 2.
- CAN DIAGNOSIS
With CONSULT
Perform CAN diagnosis function on CONSULT.
NOTE: If ECU is not equipped, an error will be displayed on CAN diagnosis function. However it is not malfunction on the vehicle. Refer to Vehicle Equipment Identification Information .Is any error detected?
YES
GO TO 3.
NO
CAN communication circuit is normal.
- NETWORK GROUP TROUBLE DIAGNOSIS
Perform the diagnosis for the error occurred network group.
NOTE: If error occurred in plural network, check network group according to priority in the table.Priority
Network Group
Reference
1
Diagnostic CAN communication
2
Body CAN communication 1
3
Chassis CAN communication 1
4
Powertrain CAN communication
5
Chassis CAN communication 2
6
Multifunction media CAN communication
7
Body CAN communication 2
GO TO 4.
- REPAIR OR REPLACE THE MALFUNCTIONING PART
- Repair or replace the malfunctioning part.
- Reconnect parts or connectors disconnected during Diagnosis Procedure again after repair and replacement.
GO TO 5.
- FINAL CHECK
- Check all DTC. If DTC is detected, erase DTCs.
- Perform CAN diagnosis function on CONSULT.
Is any error detected?
YES
GO TO 3.
NO
INSPECTION END