Diagnosis Procedure
- CHECK DTC WITH COMBINATION METER
Check that DTC is not detected with combination meter.
Is the inspection result normal?
YES
GO TO 2.
NO
Refer to DTC Index .
- CHECK CAN COMMUNICATION SYSTEM DIAGNOSIS
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart .
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace harness.
- REPLACE COMBINATION METER AND ERASE DTC
- Turn ignition switch OFF.
- Replace combination meter. Refer to Removal and Installation .
- Turn ignition switch ON.
- Select "Self Diagnostic Result" mode of "H/L control module LH" using CONSULT.
- Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .
Is DTC detected?
YES
Replace front combination lamp LH. Refer to Removal and Installation .
NO
INSPECTION END