LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Symptom Diagnosis & Removal And Installation) (Except Hybrid) >> Removal And Installation >> Fluid Cooler System >> VK56VD (2WD) >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove air duct (inlet). Refer to Exploded View .
  2. Remove engine under cover and engine under cover rear with a power tool. Refer to Exploded View .
  3. Remove A/T fluid cooler hose A and A/T fluid cooler hose B.
  4. Remove exhaust mounting bracket with power tool. Refer to Exploded View .
  5. Disconnect heated oxygen sensor 2 connectors (A).
    G04875906Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Vehicle front

    SYMBOL

    : Bolt
  6. Remove heated oxygen sensor 2 harness (B) from clips (1).
  7. Remove bracket (2) from A/T assembly. Refer to Exploded View .
  8. Remove the A/T fluid cooler tube mounting bolts.
    NOTE: Cap or plug openings to prevent fluid from spilling.
  9. Remove the clips and bands fixing two A/T fluid cooler tubes.
  10. Remove the A/T fluid cooler tubes one at a time from the vehicle.
    CAUTION: Be careful not to bend A/T fluid cooler tubes.
scientia non olet · About LEMON Manuals