Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to Diagnosis Procedure .
Is the inspection result normal?
YES
GO TO 2.
NO
Repair or replace the error-detected parts.
- PERFORM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for "ALL MODE AWD/4WD".
Is any DTC detected?
YES
Check the DTC. Refer to DTC Index .
NO
GO TO 3.
- CHECK AWD WARNING LAMP SIGNAL
- Turn the ignition switch ON.CAUTION: Never start the engine.
- Check "4WD WARN LAMP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
Does the item on "DATA MONITOR" indicate "On"?
YES
Perform the trouble diagnosis for combination meter power supply circuit. Refer to Diagnosis Procedure .
NO
Replace AWD Control Unit. Refer to Removal and Installation .
- Turn the ignition switch ON.