Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• Be careful not to damage brake booster stud bolt threads. If brake booster is tilted during installation, the dash panel may damage the threads.
• Never deform or bend the brake tubes when installing the brake booster.
• Always use a gasket between the brake booster and the dash panel.
• Replace the clevis pin if it is damaged. Refer to Inspection and Adjustment .
• Install the brake pedal assembly and brake booster mounting nuts, and tighten it to the specified torque. Refer to Exploded View .
• After installation, perform the air bleeding. Refer to Bleeding Brake System .
• Perform inspection after installation. Refer to Inspection and Adjustment .