Diagnosis Procedure
- CHECK DOOR MIRROR MOTOR INPUT SIGNAL
- Turn Ignition Switch OFF.
- Disconnect door mirror connector.
- Turn Ignition Switch ON.
- Check voltage between door mirror harness connector and ground.
(+)
(-)
Condition
Voltage (V)
(Approx.)
Door mirror
Connector
Terminals
D3 (Driver side)
D33 (Passenger side)
10
Ground
Door mirror remote control Switch
DOWN / RIGHT
12
Other than the above
0
11
LEFT
12
Other than the above
0
12
UP
12
Other than the above
0
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 2.
- CHECK DOOR MIRROR MOTOR CIRCUIT
- Turn Ignition Switch OFF.
- Disconnect Automatic Drive Positioner Control Unit connector.
- Check continuity between Automatic Drive Positioner Control Unit harness connector and door mirror harness connector.[driver side]
Automatic Drive Positioner Control Unit
Door mirror (driver side)
Continuity
Connector
Terminal
Connector
Terminal
M51
12
D3
10
Existed
23
12
24
11
[passenger side]Automatic Drive Positioner Control Unit
Door mirror (passenger side)
Continuity
Connector
Terminal
Connector
Terminal
M51
22
D33
10
Existed
10
12
11
11
- Check continuity between Automatic Drive Positioner Control Unit harness connector and ground.[driver side]
Automatic Drive Positioner Control Unit
Ground
Continuity
Connector
Terminal
M51
12
Not existed
23
24
[passenger side]Automatic Drive Positioner Control Unit
Ground
Continuity
Connector
Terminal
M51
22
Not existed
10
11
Is the inspection result normal?
YES
Replace Automatic Drive Positioner Control Unit. Refer to Removal and Installation .
NO
Repair or replace harness or connector.
- CHECK DOOR MIRROR MOTOR
Check Door Mirror Motor.
Refer to Component Inspection .
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Replace door mirror. Refer to Removal and Installation .