Diagnosis Procedure
- CHECK OIL PRESSURE WARNING LAMP
Perform auto active test. Refer to Diagnosis Description .
Is oil pressure warning lamp blinking?
YES
GO TO 2.
NO
GO TO 5.
- CHECK IPDM E/R OUTPUT VOLTAGE
- Turn ignition switch OFF.
- Disconnect the oil pressure switch connector.
- Turn ignition switch ON.
- Check voltage between the oil pressure switch harness connector and ground.
Terminals
Voltage
(Approx.)
(+)
(-)
Oil pressure switch
Ground
Connector
Terminal
F37
1
12 V
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 4.
- CHECK OIL PRESSURE SWITCH
Perform a unit check for the oil pressure switch. Refer to Component Inspection .
Is the inspection result normal?
YES
Replace IPDM E/R. Refer to Removal and Installation .
NO
Replace oil pressure switch. Refer to Disassembly and Assembly (2WD models) or Removal and Installation (AWD).
- CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT
Check the oil pressure switch signal circuit. Refer to Diagnosis Procedure .
Is the inspection result normal?
YES
GO TO 5.
NO
Repair harness or connector.
- CHECK COMBINATION METER INPUT SIGNAL
Connect CONSULT and perform an input signal check for the Combination Meter. Refer to Component Function Check .
Is the inspection result normal?
YES
Replace Combination Meter. Refer to Removal and Installation .
NO
Replace IPDM E/R. Refer to Removal and Installation .