Configuration (AFS Control Unit): Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing AFS Control Unit. (For details, refer to Work Procedure .)

Configuration has three functions as follows.

Function		Description
Read / Write Configuration	Before Replace ECU	Reads the vehicle configuration of current AFS Control Unit. Saves the read vehicle configuration.
	After Replace ECU	Writes the vehicle configuration with saved data.
Manual Configuration		Writes the vehicle configuration with manual selection.

CAUTION: When replacing AFS Control Unit, always perform "Read / Write Configuration" or "Manual Configuration" with CONSULT. Or not doing so, AFS Control Unit function does not operate normally.

Complete the procedure of "Read / Write Configuration" or "Manual Configuration" in order.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
If you set incorrect "Read / Write Configuration" or "Manual Configuration", incidents might occur.