Work Procedure

WRITING VEHICLE SPECIFICATION
Perform writing vehicle specification.

When writing saved data

GO TO 2.

When writing manually

GO TO 3.
PERFORM WRITING SAVED DATA
With CONSULT
1. Turn ignition switch ON.
2. Select "Configuration" mode of "ADAPTIVE LIGHT" using CONSULT.
3. Perform "After Replace ECU" of "Read / Write Configuration" to write vehicle specification.
WORK END
PERFORM WRITING MANUALLY
With CONSULT
1. Turn ignition switch ON.
2. Select "Configuration" mode of "ADAPTIVE LIGHT" using CONSULT.
3. Select "Manual Configuration", and write the vehicle specification to AFS Control Unit. Refer to Configuration List .
  CAUTION:
  - Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
  - Make sure to select "OK" even if the indicated configuration of brand new AFS Control Unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized.
  NOTE: If items are not displayed, touch "Next". Refer to Configuration List for written items and setting value.
WORK END