Adjustment After Installation

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

Adjust A/T fluid level. Refer to ADJUSTMENT .
Adjust A/T position. Refer to INSPECTION AND ADJUSTMENT .
Perform "CLUTCH 1 POSITION LEARNING". Refer to DESCRIPTION .
CAUTION:
If concentric slave cylinder (CSC) component parts are replaced, perform "BLEEDING CONCENTRIC SLAVE CYLINDER (CSC) " first. Refer to WORK PROCEDURE .
If a part number of HPCM is other than "237A0 4HC0C", "237A0 4HC0D", "237A0 4HC1C" and "237A0 4HC1D", perform clutch 2 initial adaptation (inspection mode 6). Refer to DESCRIPTION .
Confirm the part number of HPCM by "ECU identification information" of "EV/HEV" of CONSULT.
Perform "ADDITIONAL SERVICE WHEN REPLACE TRANSMISSION ASSEMBLY". Refer to DESCRIPTION .