Diagnosis Procedure
- CHECK DTC WITH COMBINATION METER
Check that DTC is not detected with combination meter.
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Refer to DTC INDEX .
- CHECK CAN COMMUNICATION SYSTEM DIAGNOSIS
Perform the trouble diagnosis for CAN communication system. Refer to TROUBLE DIAGNOSIS FLOW CHART .
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness.
- REPLACE COMBINATION METER AND ERASE DTC
- Turn ignition switch OFF.
- Replace combination meter. Refer to REMOVAL AND INSTALLATION .
- Turn ignition switch ON.
- Select "Self Diagnostic Result" mode of "H/L control module LH" using CONSULT.
- Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC DESCRIPTION .
Is DTC detected?
YES
Replace front combination lamp LH. Refer to REMOVAL AND INSTALLATION .
NO
INSPECTION END