DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2.
- CHECK DTC DETECTION
With CONSULT
- Perform "INSPECTION MODE 5". Refer to DESCRIPTION .
- Start engine and wait at least 5 seconds.
- Perform "All DTC Reading".
- Check DTC of "MOTOR CONTROL".
Is the DTC U0100, U0101, U0111, or U0293 detected?
YES
GO TO STEP 3.
NO - 1 (DTC U0100, U0101, U0111, or U0293 is stored in "MOTOR CONTROL" at the time of receiving.)
GO TO STEP 3.
NO - 2 (Repaired after performing DIAGNOSIS PROCEDURE .)
INSPECTION END
- PERFORM CAN DIAGNOSIS
- Perform "CAN Diagnosis".
- Check diagnosis results.
Go to DIAGNOSIS PROCEDURE .