DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 8 V or more.
GO TO STEP 2 .
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Check DTC.
Is DTC detected?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO - 1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO - 2
Confirmation after repair: INSPECTION END