LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q50 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Hybrid Motor System (Diagnostic Trouble Codes (DTCS) P2122-P31FF And Circuit Diagnosis) (Hybrid)) >> DTC / Circuit Diagnosis >> DTC P2138: App Sensor >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK DTC PRIORITY

    If DTC P2138 is displayed with DTC P3157, first perform the confirmation procedure (trouble diagnosis) for DTC P3157.

    Is applicable DTC detected?

    YES 

    Perform diagnosis of applicable. Refer to DTC INDEX .

    NO 

    GO TO STEP 2  .

  2. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is 8 V or more at idle. 

    GO TO STEP 3  .

  3. PERFORM DTC CONFIRMATION PROCEDURE

    1. Turn ignition switch ON.
    2. Depressed accelerator pedal and maintain it more than 2 seconds.
    3. Released accelerator pedal.
    4. Check DTC.

    Is DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals