Component Location
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of NISSAN NORTH AMERICA, INC.
|
 |
Behind of glove box |
 |
Steering gear assembly |
 |
Behind of front bumper (right side) |
 |
Behind of front bumper (left side) |
 |
Steering column assembly and steering shaft assembly |
|
|
| No. |
Component |
Function |
 |
HPCM |
- Transmits mainly the following signals to steering force control module via CAN communication.
- Power steering activation request signal
- Engine speed signal
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
Drive mode select switch |
- Drive mode is selectable among PERSONAL, SPORT, and STANDARD by the operating the switch.
- Output the status of drive mode to the chassis control module.
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
TCM |
- Transmits mainly the following signals to steering force control module via CAN communication.
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
BCM |
- Transmits mainly the following signals to steering force control module via CAN communication.
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
ABS actuator and electric unit (control unit) |
- Transmits mainly the following signals to steering force control module via CAN communication.
- Front LH wheel sensor signal
- Front RH wheel sensor signal
- Vehicle speed signal
- Side G signal
- Yaw rate signal
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
Chassis control module |
- Transmits mainly the following signals to steering force control module via CAN communication.
- Drive mode signal
- Steering angle sensor signal
- Transmits mainly the following signals to steering angle main control module via Chassis communication.
- Active lane control signal
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
Combination meter
(Steering warning lamp) |
- Transmits mainly the following signals to steering force control module via CAN communication.
- For detailed installation location, refer to COMPONENT LOCATION
.
- Turns ON the power steering warning lamp according to the signal from steering force control module via CAN communication.
- For steering warning lamp, refer to WARNING LAMP/INDICATOR LAMP .
|
 |
Steering angle sensor |
- Transmits mainly the following signals to steering force control module via CAN communication.
- Steering angle sensor signal
- Steering angle sensor malfunction signal
- For detailed installation location, refer to COMPONENT LOCATION
.
|
 |
Steering force control module |
STEERING FORCE CONTROL MODULE |
 |
Steering angle sub actuator |
Steering angle sub motor |
STEERING ANGLE ACTUATOR |
| Sub motor angle sensor |
| Sub reduction gear |
 |
Steering angle main actuator |
Steering angle main motor |
STEERING ANGLE ACTUATOR |
| Main motor angle sensor |
| main reduction gear |
| Steering torque sensor |
 |
Steering angle sub control module |
STEERING ANGLE SUB CONTROL MODULE |
 |
Steering angle main control module |
STEERING ANGLE MAIN CONTROL MODULE |
 |
Steering clutch |
STEERING CLUTCH |
 |
Steering force actuator |
STEERING FORCE ACTUATOR |