Diagnosis Procedure

1. Start the engine.
2. Check that the Blind Spot Intervention system settings is selectable in the vehicle information display.

Is the inspection result normal?

YES 

GO TO STEP 3. 

NO 

GO TO STEP 2. 

1. Perform self-diagnosis with CONSULT.
2. Check if the DTC is detected in self-diagnosis results of "ICC/ADAS" and "METER/M&A". Refer to the following.
   • ICC/ADAS: DTC INDEX .
   • METER/M&A: DTC INDEX .

Is any DTC detected?

YES 

Repair or replace malfunctioning parts.

NO 

INSPECTION END

Check that "BSI SELECT" operates normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT.

Is the inspection result normal?

YES 

Refer to SYSTEM DESCRIPTION .

NO 

GO TO STEP 4. 

Operate the vehicle information display switch to check that the vehicle information display operates properly.

Is the inspection result normal?

YES 

Replace the ADAS control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace malfunctioning parts.