Diagnosis Procedure

CHECK RETRACT MOTOR OPERATION SIGNAL CIRCUIT [BETWEEN AROUND VIEW MONITOR CONTROL UNIT AND DOOR MIRROR (PASSENGER SIDE)]

Disconnect around view monitor control unit connector and door mirror (passenger side) connector.

Check whether or not continuity between around view monitor control unit harness connector and door mirror (passenger side) harness connector is normal.

Around view monitor control unit		Door mirror (passenger side)		Continuity
Connector	Terminal	Connector	Terminal	Existed
M48	30	D23	8
	32		9

Check whether or not continuity between around view monitor control unit harness connector and ground is normal.

Around view monitor control unit		Ground	Continuity
Connector	Terminal		Not existed
M48	30
	32

Is the check result normal?

YES

Perform diagnosis of door mirror (passenger side) retract motor operation signal circuit. Refer to WIRING DIAGRAM .

Repair the harnesses or connectors.