Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

PERFORM WRITING UNIT CHARACTERISTICS
1. Erase self-diagnostic result for "ALL MODE AWD/4WD".
2. Perform writing unit characteristics. Refer to WORK PROCEDURE .
3. Turn the ignition switch OFF to ON.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is any DTC except "P181F" detected?

YES

Perform trouble diagnosis for detected DTC. Refer to DTC INDEX .

NO

GO TO STEP 2 .

PERFORM SELF-DIAGNOSIS AGAIN

With CONSULT

Perform "DTC CONFIRMATION PROCEDURE" (self-diagnosis) again. Refer to DTC INDEX .

Is DTC "P181F" detected?

YES

Replace AWD control unit. Refer to REMOVAL AND INSTALLATION .

NO

Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.