Removal And Installation: Installation

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

After work is completed, bleed air from brake tube. Refer to BLEEDING BRAKE SYSTEM .
Adjust the neutral position of steering angle sensor. Refer to WORK PROCEDURE .
Perform calibration of yaw rate/side/decel G sensor. Refer to WORK PROCEDURE .

CAUTION:

To install, use flare nut crowfoot and torque wrench.
Do not apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
Do not install actuator by holding harness.
After installing harness connector in the ABS actuator and electric unit (control unit), make sure connector is securely locked.