LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Brake System (Except Hybrid)) >> Periodic Maintenance >> Brake Fluid >> Bleeding Brake System

Bleeding Brake System

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • While bleeding, pay attention to master cylinder fluid level.
  • Before working, disconnect ABS actuator and electric unit (control unit) connectors or negative battery terminal. Refer to REMOVAL AND INSTALLATION .
  1. Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector or negative battery terminal. Refer to REMOVAL AND INSTALLATION .
  2. Connect a vinyl tube to front right brake caliper bleeder valve.
  3. Fully depress brake pedal 4 or 5 times.
  4. With brake pedal depressed, loosen bleeder valve to bleed air in brake line, and then tighten it immediately.
  5. Repeat steps 3 and 4 until all of the air is out of the brake line.
  6. Tighten the bleeder valve to the specified torque. Refer to EXPLODED VIEW  (front disc brake), EXPLODED VIEW  (rear disc brake).
  7. Repeat steps 2 through 6, with master cylinder reservoir tank filled at least halfway. Bleed the air in the following order from the front right, front left, rear right, rear left.
scientia non olet · About LEMON Manuals