LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Brake System (Except Hybrid)) >> Periodic Maintenance >> Brake Pedal >> Adjustment >> Brake Pedal Height

Brake Pedal Height

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument lower panel LH. Refer to REMOVAL AND INSTALLATION .
  2. Disconnect the harness connectors from the stop lamp switch and brake pedal position switch.
  3. Turn the stop lamp switch and brake pedal position switch 45° counterclockwise.
  4. Loosen the input rod lock nut (1). Adjust the brake pedal height to the specification.
    G05207934Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Check the height with the floor trim removed.
    • The threaded end of the input rod (2) must project to the inner side (L) of the clevis (3).
    Brake pedal height (H1) : Refer to BRAKE PEDAL .
    G05729476Courtesy of NISSAN NORTH AMERICA, INC.
  5. Tighten the input rod lock nut to specification. Refer to EXPLODED VIEW .
  6. Check the brake pedal for smooth operation.
    CAUTION:

    The stop lamp must turn off when the brake pedal is released.

scientia non olet · About LEMON Manuals