Inspection Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Connect recovery/recycling/recharging equipment (for HFC - 134a) or manifold gauge.

Start the engine, and set to the following condition.

TEST CONDITION

Surrounding condition		Indoors or in the shade (in a well - ventilated place)
Vehicle condition	Door	Closed
	Door glass	Full open
	Hood	Open
	Engine speed	Idle speed
A/C condition	Temperature control switch or dial	Full cold
	A/C switch	ON
	Air outlet	VENT (ventilation)
	Intake door position	Recirculation
	Fan (blower) speed	Maximum speed set

Maintain test condition until A/C system becomes stable. (Approximately 10 minutes)
Check that test results of "recirculating - to - discharge air temperature" and "ambient air temperature - to - operating pressure" are within the specified value.
When test results are within the specified value, inspection is complete.
If any of test result is out of the specified value, perform diagnosis by gauge pressure. Refer to SYMPTOM TABLE .