LH: Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK TOUCH SENSOR INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Check voltage between touch sensor LH harness connector and automatic back door control module harness connector.

      (+)		(-)		Condition		Voltage (Approx.)
      Touch sensor LH		Automatic back door control module
      Connector	Terminal	Connector	Terminal
      D556	1	B55	13	Touch sensor LH	Detect obstruction	1.8 - 5 V
      					Other than above	2.72 - 7.27 V

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

2. CHECK TOUCH SENSOR LH CIRCUIT 
   1. Disconnect automatic back door control module and touch sensor LH connector.
   2. Check continuity between automatic back door control module harness connector and touch sensor LH harness connector.

      Automatic back door control module		Touch sensor LH		Continuity
      Connector	Terminal	Connector	Terminal
      B55	2	D556	1	Yes

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B55	2		No

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

3. CHECK TOUCH SENSOR LH GROND CIRCUIT 
   1. Disconnect automatic back door control module and touch sensor LH connector.
   2. Check continuity between automatic back door control module harness connector and touch sensor LH harness connector.

      Automatic back door control module		Touch sensor LH		Continuity
      Connector	Terminal	Connector	Terminal
      B55	13	D556	2	Yes

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B55	13		No

      Is the inspection result normal? 

      YES: GO TO 4.

      NO: Repair or replace harness.

4. CHECK TOUCH SENSOR LH GROND CIRCUIT 2 
   1. Connect automatic back door control module and touch sensor LH connector.
   2. Check voltage between automatic back door control module harness connector and ground.

      (+)		(-)	Voltage (Approx.)
      Automatic back door control module
      Connector	Terminal
      B55	13	Ground	0.01 - 0 V

      Is the inspection result normal? 

      YES: GO TO 5.

      NO: Repair or replace harness.

5. CHECK TOUCH SENSOR LH 

   Refer to "LH: COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 6.

   NO: Replace touch sensor LH. Refer to "TOUCH SENSOR: REMOVAL AND INSTALLATION ".

6. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.