Precautions For Blind Spot Intervention

Do not use the Blind Spot Intervention system under the following conditions because the system may not function properly.

During bad weather (e.g. rain, fog, snow, wind, etc.)
When driving on slippery roads, such as on ice or snow, etc.
When driving on winding or uneven roads.
When there is a lane closure due to road repairs.
When driving in a makeshift lane.
When driving on roads where the lane width is too narrow.
When driving with a tire that is not within normal tire conditions (e.g. tire wear, low tire pressure, installation of spare tire, tire chains, non-standard wheels).
When the vehicle is equipped with non-original brake parts or suspension parts.

The camera may not detect lane markers in the following situations and the Blind Spot Intervention system may not operate properly.

On roads where there are multiple parallel lane markers; lane markers that are faded or not painted clearly; yellow painted lane markers; nonstandard lane markers; lane markers covered with water, dirt, snow, etc.
On roads where discontinued lane markers are still detectable.
On roads where there are sharp curves.
On roads where there are sharply contrasting objects, such as shadows, snow, water, wheel ruts, seams or lines remaining after road repairs.
On roads where the traveling lane merges or separates.
When the vehicle is traveling direction does not align with the lane markers.
When traveling close to the vehicle in front of driver, which obstructs the lane camera unit detection range.
When rain, snow or dirt cover to the windshield in front of a lane camera unit.
When the headlights are not bright due to dirt on the lens or if aiming is not adjusted properly.
When strong light enters a lane camera unit. (e.g. light directly shines on the front of the vehicle at sunrise or sunset.)
When a sudden change in brightness occurs. (e.g. when the vehicle enters or exits a tunnel or under a bridge.)

The Blind Spot Intervention system will not operate if your vehicle is on a lane marker when another vehicle enters the detection zone. In this case only the BSW system operates.
Blind Spot Intervention braking will not operate or will stop operating and only a warning chime will sound under the following conditions.