LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Driver Assistance System (Blind Spot Warning & Blind Spot Intervention) (Except Hybrid) >> Symptom Diagnosis >> BSW/BSI System Settings Cannot Be Turned On/Off In Vehicle Information Display >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK BLIND SPOT INTERVENTION SYSTEM SETTING 
    1. Start the engine.
    2. Check that the Blind Spot Intervention system settings is selectable in the vehicle information display.

    Is the inspection result normal? 

    YES: GO TO  3.

    NO: GO TO  2.

  2. PERFORM THE SELF-DIAGNOSIS 
    1. Perform self-diagnosis with CONSULT.
    2. Check if the DTC is detected in self-diagnosis results of "ICC/ADAS" and "METER/M&A". Refer to the following.

    Is any DTC detected? 

    YES: Repair or replace malfunctioning parts.

    NO: INSPECTION END

  3. CHECK DATA MONITOR OF ADAS CONTROL UNIT 

    Check that "BSI SELECT" operates normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT.

    Is the inspection result normal? 

    YES: Refer to "BLIND SPOT INTERVENTION SYSTEM: SYSTEM DESCRIPTION ".

    NO: GO TO  4.

  4. CHECK THE VEHICLE INFORMATION DISPLAY SWITCH 

    Operate the vehicle information display switch to check that the vehicle information display operates properly.

    Is the inspection result normal? 

    YES: Replace the ADAS control unit. Refer to "REMOVAL AND INSTALLATION ".

    NO: Repair or replace malfunctioning parts.

scientia non olet · About LEMON Manuals